To directly to the 2d dash kits page for your make:

To directly to the 3D dash kits page for your make:

What is a Dashboard Trim Kit?

Dash kits are a decorative interior trim that is installed on top of your stock HARLEY DAVIDSON factory plastic pieces such as center consoles, door trims, speedometer surround, overhead console etc. ExoticWoodDash sells wood, carbon fiber, and synthetic dash kits made by brand names such as Sherwood, Upgrade, B&I trims, and of course, our own ExoticWoodDash kits.

History of Dashboard Trim Kits:

Years ago, the presence of genuine wood dash trim would distinguish British-made cars from their American counterparts. The accented wood dashboards of Jaguars and Bentleys always had that "Classy Look." In later years, wood dash kits became available in the United States but the method employed was labor intensive and costly. Artisans cut thin pieces of timber to certain shapes and then would hand stain each individual piece, rubbing and polishing until the finish was deep and rich. These wood dash panels were then fixed to the dash with screws and pins. This process caused wood accented dashboards to be a very expensive option, usually costing $1,000-$1,500, and generally offered only through new car dealerships. The breakthrough occurred when 3M developed a double-sided adhesive tape that was then used to affix each dash kit piece of wood or synthetic veneer to the dash. Not only was the installation time of wooden dashkits dramatically reduced, but the new process was so easy that any one could install a wood kit without professional assistance. Today, wood dash kits are completely affordable and an easy do-it-yourself item. A wood dash kit is just as classy and beautiful today as it was in the old days thanks to the advances in the technology of wood dash kits.

HARLEY DAVIDSON Dash Kit Installation Instructions:

The following are the steps to correctly installing a wood dash kit:

1. Check the fit and alignment of your dash kit pieces to make sure you have been sent the correct dash kit for your HARLEY DAVIDSON . Do not remove the red backing of your dash kit pieces at this time.
2. Clean the surface of your HARLEY DAVIDSON dash with alcohol wipes. This insures the dash kits pieces will not have dust particles between the adhesive and the dashboard.
3. If the temperature is below 70 degrees Fahrenheit we recommend heating the dash kit pieces with a hair dryer or heat gun. This makes the dash kit pieces more pliable and easier to install.
4. Carefully apply the adhesion promoter to the dash kit pieces and apply the dash kit to the surface of your HARLEY DAVIDSON dash.
5. When installing larger dash kit pieces, carefully position the dash kit piece in the correct place on your HARLEY DAVIDSON dash. Pull back top half and remove red dash piece liner from the middle back to the top and then remove the dash piece red liner and continue with the middle to the bottom. For smaller dash kit pieces, the entire dash piece red liner can be removed at once.
6. To complete the installation of your dash kit pieces, firmly press each dash kit piece into the correct position on your dash.
7. After installation of each dash kit piece is complete, use a soft cloth or sponge to wipe each dash kit piece.
8. Enjoy your new HARLEY DAVIDSON Dash kit!

Were you looking for a different make?